Emerson CF2500OB01, CF2500HTW01, CF2500S01 Unpacking Instructions, Tools Needed for Assembly

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
Three wire connectors (supplied.)	One wire stripper

MATERIALS

Wiring, outlet box and box connectors must be of type required by the local code. The minimum wire would be a

3-conductor (2-wire with ground) of size shown at right:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan. If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson. Substitution of parts or accessories not designated for use with this product by Emerson could result in personal injury or property damage.

1.Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following:

a.Fan motor and housing assembly

b.One motor cover

c.One ceiling cover

d.Five blade flanges

e.One hanger ball/downrod assembly

f.One hanger bracket

g.One switch housing cover assembly

h.One uplight lead assembly

i.One loose parts bag containing:

1.One setscrew

2.One 5/32" hex wrench

3.One 3/16” hex wrench

4.Eleven 10-32 x 5/8" oval head screws

5.Two 1” threaded studs

6.Two 1-1/4” threaded studs

7.Four knurled knobs

8.Three wire connectors

9.Four 8-32 x 3/8" flat head screws

10.One pull chain pendant and coupling

11.One hairpin clip

12.One clevis pin

13.Four lockwashers

14.Sixteen 10-24 x 3/8" pan head screws

15.Sixteen flat washers

NOTE: Place the parts from the loose parts bags in small containers to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

NOTE: Fan blades are ordered separately and are packaged in separate carton.

		MOTOR
		COVER
UPLIGHT LEAD	HANGER BALL/
ASSEMBLY
	DOWNROD	SWITCH HOUSING
LOOSE	ASSEMBLY
		COVER ASSEMBLY
PARTS BAG

CEILING

COVER

HANGER

BRACKET

BLADE

FLANGES

FAN MOTOR AND

HOUSING ASSEMBLY

FOAM PACKING

CARTON

3