BP7335 Palazzo 1/9/07 9:05 AM Page 11
!WARNING
Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.
OUTLET
BOX
TWO SCREWS |
|
SUPPLIED |
|
WITH |
|
OUTLET BOX | HANGER |
| BRACKET |
Figure 18 | TAB |
|
How to Wire
Your Ceiling Fan
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
!WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
2. Carefully lift the fan and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 19). Be sure the groove in the ball is lined up with the tab on the hanger bracket (Figure 18).
!WARNING
Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.
NOTE: CEILING COVER, SUPPLY WIRES AND FAN WIRES OMITTED FOR CLARITY.
CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan, light kit or receiver.
1. Pull the wire leads, coming from the end of the downrod, and the supply wires through the open side of the hanger bracket. (Figure 20).
2. Position the SW105 Receiver in the ceiling cover so that the flat side of the receiver faces up and the open portion of the receiver is to the right, as shown in Figure 20.
Figure 19
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/ DOWNROD ASSEMBLY
3. Using wire connectors (supplied), make wiring connections as follows (Figure 20 and 21):
a. Connect the white fan wire and the |
white supply wire to the white |
receiver wire (AC IN/ MOTOR N). |
b. Connect the black fan wire to the |
black receiver wire (TO MOTOR L). |
c. Connect the black supply wire to the |
black/white receiver wire (AC IN L). |
d. Cut off the end of the blue receiver |
wire and strip back insulation 1/2- |
!WARNING
To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket.
inch from the end of the wire. |
e. Connect the blue fan wire to the blue |
receiver wire (BOTTOM LIGHT). |
11
