BP7335 Palazzo 1/9/07 9:05 AM Page 9
7. Carefully turn the fan motor assembly upside down in preparation for hanger ball/downrod installation. Place the partially assembled fan into the top half of the styrofoam as shown in Figure 11. Do not rest fan weight on the light fitter sockets.
TOP HALF OF
STYROFOAM
11. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 13). (Pin and clip are supplied in loose parts bag.) The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed.
Figure 11 | ! WARNING |
|
|
8. Remove the hanger ball from the downrod by loosening the setscrews in the hanger ball until the ball falls freely down the downrod (Figure 12). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 16.
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 13) could result in the fan falling.
12.While pulling up on the downrod, tighten the two setscrews.
PIN |
| NOTE: The setscrews must be properly | |
HANGER |
| tighten as described above, or fan | |
BALL |
| wobble could result. | |
|
| 13. The fan comes with black, blue, and | |
DOWNROD | SETSCREW | white leads that are 80” long. | |
Measure up approximately 6 to 9- | |||
|
| ||
|
| inches above the top of downrod. Cut | |
Figure 12 |
| off excess leads and strip back | |
|
| insulation 1/2” from end of leads. |
9. Loosen both setscrews in the motor 
coupling (Figure 13).
10. Separate, untwist and unkink the three motor leads. Route the motor leads through the downrod and seat the downrod in the motor coupling (Figure 13).
14.Slide the coupling cover down the downrod until it set firmly on the motor housing (Figure 14).
DOWNROD
DOWNROD | COUPLING | |
COVER | ||
| ||
HAIRPIN | CLEVIS PIN | |
CLIP |
SETSCREW (2)
Figure 14
Figure 13 | 9 |
