5)Before You Drill: Make sure there are no water plpes, gas pipes, electrical wires on other obstructions or hazards behind the wall in your chosen mounting location. If you are not sure about this. and don't know how to check, perhaps you should consider having the system mounted by someone with the necessary experience.
6)Use a 3/16" drill bit in your electric drill and drill completely through the drywall.
NOTE: The hollow wall plastic anchors included with this system are intended for installation in normal 5/8" drywall (sheetrock, plasterboard, etc). If you are installing this system on a solid wall surface such as wood, concrete, cinderblock, brick, etc. you cannot use these hollow wall anchors. In this case you must use the appropriate solid wall anchors, (not included), available at your local hardware store or home improvement center.
7)Insert the tip of the plastic anchor into the hole and use a hammer to tap the anchor all the way in until it is flush with the wall surface.
8)Insert the screw into the anchor and tighten the screw until it touches the collar on the plastic anchor. This causes the anchor to spread inside the wall and locks the anchor in place.
25
