Empire Comfort Systems CIVF-25-21 Assembly of Stove Casting, Detailed Instructions Follow

ASSEMBLY OF STOVE CASTING

Assembly of Stove Casting (Figures 6, 7, 8, 9, 10, 11 and 12) Attention: Included in the hardware package are (8) 1/4" inside diameter washers. A 1/4" washer may be used with a 1/4-20 x 3/8" bolt when assembling the stove casting parts. If a bolt hole is not tapped deep enough for a tight fit between stove casting parts, the 1/4" washer can be used as a shim to provide a tight fit.

The 1/4" washers are not required for assembly of the stove casting if all the bolt holes are tapped to a proper depth.

Additonal 1/4" washers are to be purchased locally.

1.Place porcelain casting pieces on a non-abrasive surface in order to protect the porcelain finish. The exterior of the porcelain casting pieces should be facing the non-abrasive surface.

2.The assembly of the casting is accomplished in 7 stages:

A.Attaching legs to the sides (Figure 6).

B.Attaching rear cover to sides (Figure 7).

C.Removing protective packaging from casting front and window (Figure 8).

D.Assembly of front by attaching retaining tabs and placing front on unit (Figure 8 and Figure 9).

E.Inserting firebox into partially completed assembly (Figure 10 and Figure 11).

F.Attaching firebox to rear cover (Figure 12).

G.Placing top on unit.

Detailed Instructions Follow

3.Refer to Figure 6, the leg pads will have the letter "A" and "B" stamped into the metal. Place leg pad "A" and leg pad "B" at the bottom of each casting side. Leg pad "A" attaches to the front of the casting side, right and to the rear of the casting side, left. Leg pad "B" attaches to the rear of the casting side, right and to the front of the casting side, left. Position the 3/4" flange on the leg pad against the (2) locator dimples on the casting side. The 3/4" flange must be facing upward, toward the top louver openings on the casting side. Attach the two rear leg pads to the casting sides with (2) 3/8" bolts. Attach but do not completely tighten the two front leg pads to the casting sides with (2) 3/8" bolts. Attention: The front leg pads can be adjusted to provide a snug fit between the casting front and the casting sides.

4.Attach (4) leveling bolts to the bottom of the (4) legs.

5.Align the 3/8" hole at the top of the leg with the 3/8" hole in the leg pad. Attention: For proper positioning of the leg to the leg pad the (2) 1-1/2" top edges of the leg must be placed flush and parallel to the (2) edges on the leg pad. Attach leg to leg pad by inserting (1) 1" bolt through the leg pad and into the leg, secure bolt with 1/4" nut.

6.Insert (2) 3/8" bolts into the (2) holes on the edges of the casting sides. The bolts should only be threaded half-way into the holes in order to allow for clearance when the casting back is attached to the casting sides.

Figure 6

Page 10 16938-3-0806