LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING 
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance
•Do not touch any electrical switch; do not use any phone in your building
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•If you can not reach your gas supplier, call the fire de- partment.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service tech- nician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.STOP! Read the safety information above.
2.Set the thermostat to lowest setting.
3.Turn off all electric power to the appli- ance (if applicable).
4.Lower valve cover.
5.Push in gas control knob slight-
ly and turn clockwise
to "OFF." NOTE: Knob cannot
be turn from "PILOT" to "OFF" unless knob is pushed in slightly. Do not force.
6.Wait ten (10) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low "B" in the safety information above on this plate. If you do not smell gas,
go to the next step.
7.Find pilot - The pilot is attached to the main burner behind the front log.
8.Turn gas control knob counterclockwise 
to "PILOT."
9.Push in control knob all the way and hold in. Repeatedly push the Piezo Ignitor Button until the pilot is lit. Continue
to hold the control knob in for about one (1) minute after the pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 5 through 9.
•If knob does not pop up when released, stop and immedi- ately call a qualified service technician or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.
10.Attention! Gas control has an INTERLOCK latch- ing device. When the pilot is initially lit and the safety magnet is energized (pilot stays "on"), the INTERLOCK latching device becomes operative. If the gas control is turned to "OFF" position or gas flow to the appliance shut off, the pilot cannot be relighted until the safety magnet is
11.Turn gas control knob counterclockwise 
to "ON."
12.Raise valve cover.
13.Turn on all electric power to the appliance (if ap- plicable).
14.Set thermostat to desired setting.
TO TURN OFF GAS APPLIANCE
1.Set the thermostat to lowest setting.
2.Turn off all electric power to the appliance if service is to be performed (if applicable).
3.Lower valve cover.
4.Push in gas control knob slightly and turn clockwise
to "OFF."
5.Raise valve cover.
Page 15 |
