INTRODUCTION

Always consult your local Building Department regarding regulations, codes or ordinances which apply to the installation of an unvented room heater.

This appliance may be installed in an aftermarket* permanently located, manufactured (mobile) home, where not prohibited by state or local codes.

*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer.

This appliance is only for use with the type of gas indicated on the rating plate.

Instructions to Installer

1.Installer must leave instruction manual with owner after installation.

2.Installer must have owner fill out and mail warranty card supplied with unvented room heater.

3.Installer should show owner how to start and operate unvented room heater.

This CIVF-25 is design certified in accordance with American National Standards Institute Z21.11.2 by the Canadian Standards Association as an Unvented Room Heater and should be installed according to these instructions.

Attention: During initial use of ceramic log you will detect an odor as the ceramic log is cured.Also, during the curing process the ceramic log will burn with a yellow flame.

Any alteration of the original design, installed other than as shown in these instructions or use with a type of gas not shown on the rating plate is the responsibility of the person and company making the change.

Warning:This appliance is equipped for(natural orpropane) gas. Field conversion is not permitted.

Important

All correspondence should refer to complete Model Number, Serial Number and type of gas.

Notice: During initial firing of this unit, its paint will bake out, and smoke will occur. To prevent triggering of smoke alarms, ventilate the room in which the unit is installed.

Qualified Installing Agency

Installation and replacement of gas piping, gas utilization equipment or accessories and repair and servicing of equipment shall be performed only by a qualified agency. The term "qualified agency" means any individual, firm, corporation or company which either in person or through a representative is engaged in and is responsible for (a) the installation or replacement of gas piping or (b) the connection, installation, repair or servicing of equipment, who is experienced in such work, familiar with all precautions required and has complied with all the requirements of the authority having jurisdiction.

State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts.

Sellers of unvented propane or natural gas-fired supplemental room heaters shall provide to each purchaser a copy of 527 CMR 30 upon sale of the unit.

The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54.*

*Available from the American National Standards Institute, Inc., 11 West 42nd St., New York, N.Y. 10036.

High Altitudes

For altitudes/elevations above 2,000 feet (610m), ratings should be reduced at the rate of 4 percent for each 1,000 feet (305m) above sea level. Contact the manufacturer or your gas company before changing spud/orifice size.

SPECIFICATIONS

Model

CIVF-25

Input BTU/HR (KW/H) Maximum

30,000 (8.8)

BTU/HR (KW/H) Minimum

21,000 (6.2)

Height

27 3/4" (70.5cm)

Width

25 1/2" (64.8cm)

Depth

15 1/2" (39.4cm)

Gas Inlet

3/8" (9.5mm)

Stove Casting (Must be ordered with Firebox)

CIFB-1

Flat Black

CIPB-1

Porcelain Black

CIPG-1

Porcelain Green

CIPS-1

Porcelain Sand

CIPN-1

Porcelain Navy

CIPR-1

Porcelain Red

Accessories

TMV

Millivolt Wall Thermostat - Reed Switch

FRBC-1

Battery Operated Remote Control

FRBTC-1 Battery Operated Remote Control w/Thermostat

FREC-1

Electric Remote Control

FWS-1

Wall Switch

 

CIB-2

Automatic BLower

Stone Inlay Replaces Standard Grill Top

CII-2

Stone Inlay

Empress Green

CII-3

Stone Inlay

Hunan Jade

CII-4

Stone Inlay

Gray Botticino

CII-5

Stone Inlay

Azul

CII-6

Stone Inlay

Salome

CII-7

Stone Inlay

Black Swan

16938-3-0806

Page 5

Page 5
Image 5
Empire Comfort Systems CIVF-25-21 Introduction, Specifications, Instructions to Installer, Qualified Installing Agency