Charger Features

1.DC In

Connects to Charger AC Adaptor.

2.Handset Charging Slot

a.Charge handset battery when handset is placed in cradle.

b.Refer to the handset LCD for charging status

(1)Charging: LCD screen showed “Charging”

(2)Fully Charged: battery status bar stands still and the LCD screen would display “Fully Charged”

(3)Charge Fail: Should there be any error occurred during charging mode, the LCD screen would display “Charge Fail”

3.Spare Battery Charging Slot

a.Charge spare battery when battery is placed in slot.

b.LED as the spare battery charging indicator

(1)Slot is empty and the power is on: LED is Green light

(2)Charging: LED is Orange light

(3)Fully Charged: LED returns to Green light

4.It is impossible to overcharge the battery using this charger.

Notes:

1.Fully charge battery packs before first use.

2.Both handset and spare batteries can be charged at the same time.

3.Handset will be “power on” automatically when placing on the charging slot.

4.However, if you run drain the battery, it would take around one minute for handset to auto power on.

5.The adaptor for charging station can be used as travel charger as well. However, you can’t turn off the power while you charge the handset via travel charger. A Warning message: “Unplug Travel Charger than OFF the power” will be shown on the LCD display.

~19~

Getting Started

Base Station Installation

There are three possible base station setups:

zBase station alone

zBase station plus telephone answering device

zBase station plus standard telephone

For best performance, maintain at least a distance of 1 meter (about 3 feet) between the base station and other electronic devices (e.g., TV, computer, stereo, fax machine, answer machine, cordless phone, etc.)

1.Install base station antenna.

The base station’s antenna port has a reverse-thread connector; to install antenna or cable, turn counter-clockwise; to remove, turn clockwise. Improper installation may damage the connector.

2.Plug the transformer end of the base station AC/DC adaptor into a standard AC electrical power outlet, plug the other end into the “DC In” jack on the back of the base station.

a.The base adaptor’s DC plug is larger in dimension than the charger’s DC plug. The charger adaptor’s DC plug will not fit into the base’s DC In jack.

b.The base station’s power supply (DC Adaptor) and telephone line should be plugged into a surge protector with phone line protection.

3.Plug phone cord into the “LINE” Jack

4.A standard telephone or answering machine can be plugged into the adjacent receptacle on the bottom of the base station marked TEL

5.To use the Music/Message-On-Hold feature: Connect one end of a standard audio cable into a radio or audio player, and plug the other (3.5 mm) end into the MOH jack on back of the base.

~20~

Page 10
Image 10
EnGenius Technologies 3616A-SN1302 manual Charger Features, Getting Started