Enterasys Networks DFE-Gold Series Managing Configuration and Image Files

Managing Configuration and Image Files clear router telnet
2-80 Startup and General Configuration
Managing Configuration and Image Files
MatrixSeriesdevicesprovideasingleconfigurationinterfacewhichallowsyoutoperformboth
switchandrouterconfigurationwiththesamecommandset.Thedevicealsoprovidesredundant,
distributedcopiesofeachimagefileintheeventthatDFEmodulesareaddedorremovedfrom
theMatrixchassis.WhenmanagingconfigurationandimagefilesontheMatrixSeriesdevice,itis
importanttorememberthefollowingconsiderations:
•Allmoduleswillhavethesameimagefilesloaded.Ifamoduleisinsertedintoachassis,any
imagesuniquetothatmodulewillbedeleted,andanyimagesnotonthatmodulewillbe
copiedtoit.
• Configurationfilesarestoredperslot,witheachslotinthechassiscarryinguniquefileswith
itandnotinheritingfiles.
TheMatrixSeriesdevicesnowsupportascriptfeaturethatallowsyoutoexecuteapreviously
createdscriptfilecontainingCLIcommands,andatthetimeofexecution,enteroptional
argumentsthatmodifytheactionsofthecommands.Thisfeatureisintendedtosimplifythe
configurationofportsandVLANs,bycreatingscriptfilescontaininggroupsofcommandsthat
youwanttorunonthesameport‐stringorVLANid.Atthetimeofexecution,youpassinthe
port‐string,VLANid,andanyotherrequiredargumentsthatyouwantthecommandstooperate
on.Refertothescriptcommand,“script”onpage 2‐88.
Thefollowingsectiondescribesthecommandsetformanagingbothswitchandrouter
configuration.
Fordetailsonperformingabasicroutingconfiguration(whileoperatinginroutermode),referto
“PerformingaBasicRouterConfiguration”onpage 16‐11.
Fordetailsondownloadinganewfirmwareimage,referto“DownloadingaNewFirmware
Image”onpage 2‐72.
Fordetailsonreviewingandselectingthebootfirmwareimage,referto“ReviewingandSelecting
aBootFirmwareImage”onpage 2‐72.
Purpose
Toview,manage,andexecuteconfigurationandimagefiles.
Commands
Note: The commands described in this section manage both switch and router configuration
parameters, but must be executed from the switch CLI.
For information about... Refer to page...
dir 2-81
show file 2-83
show config 2-85
configure 2-86
copy 2-86
delete 2-87
script 2-88