Enterasys Networks DFE-Gold Series Using WebView, Starting and Navigating the Command Line Interface

Startup and General Configuration Summary
Enterasys Matrix DFE-Gold Series Configuration Guide 2-7
Using WebView
BydefaultWebView(EnterasysNetworks’embeddedwebserverfordeviceconfigurationand
managementtasks)isenabledonTCPportnumber80oftheMatrixSeriesdevice.Youcanverify
WebViewstatus,enableordisableWebView,asdescribedinthefollowingsection.
Displaying WebView status:
TodisplayWebViewstatus,entershowwebviewattheCLIcommandprompt.
ThisexampleshowsthatWebViewisenabledonTCPport80,thedefaultportnumber.
Matrix(rw)->show webview
WebView is Enabled. Configured listen port is 80.
Enabling / disabling WebView:
ToenableordisableWebView,entersetwebview{enableodisable}attheCLIcommandprompt.
ThisexampleshowshowtoenableWebView.
Matrix(rw)->set webview enable
Starting and Navigating the Command Line Interface
Using a Console Port Connection
OnceyouhaveconnectedaterminaltothelocalconsoleportasdescribedinyourMatrixSeries
InstallationGuide,thestartupscreen,Figure 2‐1,willdisplay.YoucannowstarttheCommandLine
Interface(CLI)by
•Usingadefaultuseraccount,asdescribedin“LogginginwithaDefaultUserAccount”on
page 2‐7,or
•Usinganadministratively‐assigneduseraccountasdescribedin“Logginginwith
AdministrativelyConfiguredAccount”onpage 2‐8.
Logging in with a Default User Account
IfthisisthefirsttimeyourareloggingintotheMatrixSeriesdevice,orifthedefaultuseraccounts
havenotbeenadministrativelychanged,proceedasfollows:
1. Attheloginprompt,enteroneofthefollowingdefaultusernames:
–roforRead‐Onlyaccess,
–rwforRead‐Writeaccess.
–adminforSuperUseraccess.
2. PressENTER.ThePasswordpromptdisplays.
Note: Depending on which Matrix Series device you are using, your default command prompt may
be different than the examples shown.
Note: By default, the Matrix Series device is configured with three user login accounts: ro for Read-
Only access; rw for Read-Write access; and admin for super-user access to all modifiable
parameters. The default password is set to a blank string. For information on changing these default
settings, refer to “Setting User Accounts and Passwords” on page 2-15.