In-Band Connections

Prior to accessing the switch via a network connection, you must first configure it with a valid IP address, subnet mask, and default gateway using an out-of-band connection or the BootP protocol.

Telnet Connection

Prior to accessing the switch via an in-band Telnet connection, you must first configure it with a valid IP address, subnet mask, and default gateway using an out-of-band connection or BootP protocol. After configuring the switch’s IP parameters, you can access the on-board configuration program from anywhere within the attached network.

Use the Network Configuration menu to specify the maximum number of simultaneous Telnet sessions that are supported by the system.

In-Band Network Connection

The on-board configuration program can be accessed using Telnet from any computer attached to the network. The switch can also be managed by any computer using a Web browser (Internet Explorer 4.0 or above, or Netscape Navigator 4.0 or above), or from a network computer using network management software.

2 Management Overview

VH-8G

Page 10
Image 10
Enterasys Networks VH-8G manual In-Band Connections, Telnet Connection, In-Band Network Connection