Configuring Static Unicast Addresses | Enterasys Networks VH-8G

Configuring Static Unicast Addresses

Use the Static Unicast Address Table Configuration screen to manually configure host MAC addresses in the unicast table. You can use this screen to associate a MAC address with a specific VLAN ID and switch port as shown below.

		Vertical Horizon Local Management -- VH-8G
		Static Unicast Address Table Configuration
	VID	MAC Address	Port	Status
	------------------------------------------------------------------------
	1	00-00-00-E8-43-12	1	Permanent
	Sorted by : VID + MAC		VID	: 1	MAC: 00-00-00-00-00-00
	VID	: 1	Port	: 1
	MAC : 00-00-00-00-00-00 Status : Permanent
	[Show]	[More]		[Set]
			<OK>
		Use <TAB> or arrow keys to move. <Enter> to select

	Figure 2-50. Static Unicast Addreeess Table Configuration

Parameter		Description
VID		The VLAN group this port is assigned to.
MAC Address		The MAC address of a host device attached to this switch.
Port		The port the host device is attached to.
Status		The status for an entry can be set to:
		Permanent:	This entry is currently in use and will remain
			so after the next reset of the switch.
		DeleteOnReset:	This entry is currently in use and will remain
			so until the next reset.
		Invalid:	Removes the corresponding entry.
		DeleteOnTimeOut: This entry is currently in use and will remain
			so until it is aged out. (Refer to Address Table
			Aging Time on page 60.)
		Other:	This entry is currently in use but the
			conditions under which it will remain so differ
			from the preceding values.
[Show]		Displays the static address table sorted on VID as the primary key
		and MAC address as secondary key.
[More]		Scrolls through entries in the static address table.
[Set]		Adds the specified entry to the static address table, such as
		shown in the following example:
		VID : 1	MAC : 00-00-00-e8-34-22
		Port : 1

Status : Permanent

62 VH-8G User Interface

VH-8G

Image 70

Enterasys Networks VH-8G manual Configuring Static Unicast Addresses, Static Unicast Addreeess Table Configuration

Contents

Vertical Horizon VH-8G Gigabit Ethernet Switch Management GuidePage 9033640 9033640 Table of Contents Snmp Management Appendix A. Spanning Tree Concepts Appendix B. Virtual Lans Vlans Vi Table of Contents Required Connections Configuration OptionsManagement Overview Console Port Out-of-Band Connections Telnet Connection In-Band ConnectionsIn-Band Network Connection VH-8G User Interface Overview User Access Factory Defaults Factory Default Settings Gvrp Main Menu Selection Description Displays/configures extended bridge capabilities provided by System Information Menu System Information Menu Displaying System Information System Information Displaying Switch Version Parameter Description Management Setup Menu Management Setup Menu Changing the Network Configuration Network Configuration IP Configuration IP Configuration IP Connectivity Test Ping IP Connectivity Test Http Configuration 10. Http Configuration Configuring the Serial Port 11. Serial Port Configuration 12. Snmp Configuration Assigning Snmp Parameters Configuring Community Names 13. Snmp Communities Configuring IP Trap Managers 14. IP Trap Managers Console Login Configuration 15. Console Login Configuration Using Tftp Protocol to Download Over the Network Downloading System Software Saving the System Configuration 17. Configuration Save & Restore Configuring Management Access 18. Management Configuration Configuring the Switch 19. Device Control Menu Not implemented in the current firmware release Configuring Port Parameters 20. Port Configuration Viewing the Current Port Configuration 21. Port Information Using the Spanning Tree Algorithm 22. Spanning Tree Configuration Configuring Bridge STA Device with the lowest MAC address will then Configuring STA for Ports 24. Spanning Tree Port Configuration Viewing the Current Spanning Tree Configuration 25. Spanning Tree Information Displaying the Current Bridge STA 26. Bridge STA Information Displaying the Current STA for Ports 27. Spanning Tree Port Information Rules defining port status are Using a Mirror Port for Analysis 28. Mirror Port Configuration Configuring Port Trunks 29. Port Trunking Configuration Igmp Multicast Filtering Configuring Igmp 30. Igmp Configuration Configuring Broadcast Storm Control 31. Broadcast Storm Control Configuration Configuring Bridge MIB Extensions 32. Extended Bridge Configuration By setting this parameter to False Configuring Traffic Classes 33 .1P Configuration Port Priority Configuration 34 .1P Port Priority Configuration 802.1P Port Traffic Class Information 35 .1P Port Traffic Class Information Configuring Virtual LANs 802.1Q Vlan Base Information 802.1Q Vlan Current Table Information 37 .1Q Vlan Current Table Information 802.1Q Vlan Static Table Configuration 38 .1Q Vlan Static Table Configuration 39 .1Q Vlan Static Table Configuration Example Port Assignment Vlan Configuration 40. Port Assignment Vlan Configuration Multicast Router Port Information 41. Multicast Router Port Information Static Multicast Router Port Configuration 42. Static Multicast Router Port Configuration Igmp Member Port Configuration 43. Igmp Member Port Configuration Port Security Configuration 44. Port Security Configuration Monitoring the Switch 45. Network Monitor Menu Displaying Port Statistics 46. Port Statistics Displaying Rmon Statistics 47. Rmon Statistics Drop Events Displaying the Unicast Address Table 48. Unicast Address Table Displaying the IP Multicast Registration Table 49. IP Multicast Registration Table Configuring Static Unicast Addresses 50. Static Unicast Addreeess Table Configuration Resetting the System Logging Off the System 64 VH-8G User Interface Configuring & Monitoring the Switch Common Tasks Setting Password Protection Connecting via Telnet Checking Network Configuration StatusAssigning an IP Address Setting Snmp Management Access Viewing Switch Statistics Configuring Port Mirroring Downloading a Software Upgrade Downloading Via the Serial Port Success Downloading Via Tftp Configuring Spanning Tree Parameters Configuring VLANs Configuring Class of Service Configuring Port Operation Configuring the Unicast Address Table Setting a Default Gateway Configuring BootP Configuring Port Trunks VH-8G Snmp Management Snmp Protocol MIB Objects RFC 1213 MIB-II RFC 1643 Ethernet-Like MIB RFC 1573 Interfaces Evolution MIBRFC 1493 Bridge MIB Ieee 802.1Q Q-MIB Compiling MIB Extensions Enterasys WebsiteEnterasys Proprietary MIB Extensions Appendix A. Spanning Tree Concepts Spanning Tree FeaturesGeneral Figure A-1. Spanning Tree Using an VH-8G Switch Spanning Tree Protocol in a Network Table A-1. Spanning Tree Protocol Defaults Spanning Tree Protocol Parameters Spanning Tree Protocol Operation 9033640 Spanning Tree Concepts VH-8G Appendix B. Virtual Lans Vlans VLANs and Frame Tagging Vlan Classification VH-8G Vlan ConfigurationAssigning Ports to VLANs Port Overlapping Forwarding Tagged/Untagged Frames Automatic Vlan Registration Forwarding Traffic with Unknown Vlan Tags Appendix C. Class of Service Incoming tagged frames contain a priority level range Figure C-1. Class of Service Example Appendix D. IP Multicast Filtering Igmp Snooping and IP Multicast Filtering VH-8G Index Tftp 9033640 Index Page Page 150183-102 R01