Enviro 50-1578 technical manual Installation, Rating label is located on the back of the hopper

Installation

RATING LABEL LOCATION:

The rating label is located on the back of the hopper.

DECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE:

1.Check clearances to combustibles (see INSTALLATION - CLEARANCES TO COMBUSTIBLES and INSTALLATION - ALCOVE CLEARANCES).

2.Do not obtain combustion air from an attic, garage or any unventilated space. Combustion air may

be obtained from a ventilated crawlspace.

3.Do not install the stove in a bedroom.

4.You can vent the stove through an exterior wall behind the unit or connect it to an existing masonry or metal chimney (must be lined if the chimney is over 6” (15 cm) diameter, or over 28 inches² (180 cm²) cross sectional area). An interior vent can be used with approved pipe passing through the ceiling and roof.

5.Locate the stove in a large and open room that is centrally located in the house. This will optimize heat circulation.

6.The power cord is 8 feet (2.43 m) long and may require a grounded extension cord to reach the nearest electrical outlet.

REMOVING PELLET STOVE FROM PALLET:

Remove screws from the two (2) hold-down brackets that secure the Windsor to the pallet. Lift the brackets up to unhook from the chassis.

Hold-down brackets.

Figure 1: Removing Freestanding Stove From the Pallet.

6