Epson 10020, 100 Exit, Change settings, Exit without saving, Leaving the Setup Program, If you changed the time or date, the new setting will be in

Leaving the Setup Program

When you finish setting the options in the Setup menu, highlight the Exit option and press Enter. You see a summary such as this:

Real-timeclock	Time			13:35:31
	Date			08-30-1989
Primary serial port	Baud rate 1200 bps			Parity None
	Data length 7 bits			Stop bits	1	bit(s)
Secondary serial port	Baud	rate 1200	bps	Parity None
	Data	length 7	bits	Stop bits	1	bit(s)

Change settings

Exit without saving

** EXIT AND SAVE **

Check the list to see if all the information is correct. If any setting is incorrect, highlight Change settings and press Enter. The main Setup menu appears and you can change the setting, as necessary.

If you did not make any changes or you want to cancel the changes you made, highlight Exit without saving and press Enter. The Operation menu appears on the screen. Press 0 and Enter to return to the MS-DOS command prompt.

Note

If you changed the time or date, the new setting will be in

effect even if you exit the Setup program without saving your changes.

If you want to save the settings you made, follow these steps: 1. Remove the Reference diskette from drive A.

Changing DIP Switches and Using Setup A-13