Epson 1680 Removing the Shipping Screw, Installing the Transparency Unit

Removing the Shipping Screw

To prevent damage during shipping, a shipping screw is attached to the transparency unit to secure its lamp assembly. You must remove this screw before using the transparency unit.

1.Turn the transparency unit so the glass side faces up.

2.Use a Phillips (cross

head) screwdriver to remove the shipping screw from the hole labeled CLAMP, as shown at right.

3. Install the screw in the storage hole labeled

STOCK.

Caution: Before transporting the transparency unit, follow the procedures on page 36 to protect it from damage.

Installing the Transparency Unit

1.Make sure the scanner is turned off.

2.Remove the document cover by

grasping the back of the document cover and easing the cover up.

3. Make sure the document table is clean and dust free.

4. Position the slots on the transparency unit’s mounting bracket over the heads of the two mounting screws located at the back of the scanner.

Using Optional Equipment 21