14.Align the holes in the base (A) Fig. 8, with the holes in the two sides (B).
15.Insert a hex head flange screw (M8x1.25x16mm) through the hole in the side of the stand (B) Fig. 8, and through the hole in the base (A).
16.Thread a hex flange nut (M8x1.25) on the screw.
NOTE: Loosely tighten the hardware for further adjustment.
17.Repeat this process for the five remaining holes.
18.Attach the other side of the base in the same manner.
19.Attach the two bases together by inserting a hex head flange screw (M8x1.25x16mm) through the hole (C) Fig. 8 in each base, and thread a hex flange nut (M8x1.25) on the screw.
20.Turn the stand over so that it is resting on the base.
21.Slide the two hinges of the door (A) Fig. 9 over the hinge catches (B) on the stand.
22.Close the door until the door latch (C) Fig. 9, engages with the side (D).
23.Attach the other door in the same manner.
24.Thread a hex nut (M10x1.5) on a hex head screw (M10x1.5x100mm) approximately 1/4".
25.Thread the hex head screw (C) into the hole (A) Fig. 10 in the top of the stand.
26.Place the damping cap (A) Fig. 10A on the threaded end of the screw (C).
27.Align the holes (D) Fig. 10 on the hinges attached to the pulley guard with the two holes (B) in the top of the stand.
28.Insert a pan head screw (M5x0.8x10mm) through the hole (D) Fig. 10 in the hinge, and the hole (B) in the top of the stand.
29.Thread a hex nut (M5x0.8) on the screw and tighten securely.
30.Repeat this process for the remaining hole in the hinge and the top of the stand.
31.Confirm that the stand is level.
32.Tighten all hardware securely.
| A |
| C |
Fig. 8 | B |
|
C
D
A 
B
Fig. 9
D |
| B |
|
| C |
| A | Fig. 10 |
|
|
11 - English
