Epson 28-276 instruction manual Assembly Tools Required, Assembly Time Estimate

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

13mm Open- End Wrench - 8mm Open-End Wrench - Adjustable Wrench

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes 2 hours or less.

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

MODEL 28-206 ENCLOSED STAND ASSEMBLY

C

E

1.	Place the stand top (A) Fig. 5 on a flat surface.
2.	Align the two holes in the motor mounting plate (E)

B

A

	Fig. 5 with the two holes (B) in the stand top (A).
3.	Insert the shaft (D) through the holes in the motor
	mounting plate and the holes in the stand top.
4.	Attach the two "C" rings (C) Fig. 5 on the shaft.
5.	Align the four holes on the motor bracket with the
	four holes (C) Fig. 6 on the motor mounting plate.
	NOTE: Confirm that the motor pulley (A) Fig. 6 is
	mounted on the same side as the belt opening hole

D

C

Fig. 5

	(B).
6.	Insert a round head flange screw (M8 x 1.25 x
	16mm) through the hole in the motor bracket and
	the hole in the motor mounting plate.
7.	Thread a hex flange nut (M8x1.25) on the screw.
8.	Repeat this process for the three remaining holes.

C

A

B

Fig. 6

9.Align the holes in the side (A) Fig. 7 with the holes in the stand top (B).

NOTE: Confirm that the hinge catches (C) Fig. 7 are pointed toward the stand top.

10.Insert a hex head flange screw (M8x1.25x16mm) through the hole in the side of the stand and the hole in the top of the stand.

11.Thread a flange nut (M8x1.25)on the screw.

NOTE: Loosely tighten the hardware for further adjustment.

12.Repeat this process for the five remaining holes.

13.Attach the other stand side in the same manner.

A

Fig. 7

C

B

10 - English