operation
OPERATIONAL Controls and ADJUSTMENTS
starting and stopping the saw
Make sure that the switch is in the “OFF” position before plugging cord into outlet. Do not touch the plug’s metal prongs when unplugging or plugging in the cord
The power switch is located on the left side of the machine. To turn the machine "ON", push the green start button (A) Fig. 23. To turn the machine "OFF", push the red stop button (B).
A
B
Fig. 23
locking THE switch in the "off" position
IMPORTANT: When the tool is not in use, the switch should be locked in the "OFF" position to prevent unauthorized use, using a padlock (Fig. 24) with a 3/16" diameter shackle.
In the event of a power outage (such as a breaker or fuse trip), always move the switch to the “OFF” position until the main power is restored.
tilting the table
You can tilt the band saw table 45 degrees to the right and 10 degrees to the left.
1.To tilt the table to the right, loosen the two locking knobs (A) Fig. 25, tilt the table to the desired angle as shown on the scale (D) Figs. 25 and 26, and tighten two locking knobs (A).
2.To tilt the table (C) Fig. 26 to the left, loosen the two locking knobs (A) Fig. 25 and tilt the table to the right until you have access to the table stop (A) Fig. 26. Remove the table stop (A) Fig. 26, and tilt the table to the left 10 degrees. Tighten the two locking knobs
(A) Fig. 25.
Fig. 24
D
A
Fig. 25 |
| A |
C | E |
|
| D |
|
| A |
|
| B | F |
Fig. 26
16 - English
