12 - English
MOdEL 28-276 OPEN STANd ASSEMBLY
1. Place the stand top (A) Fig. 11 on a flat surface.
2. Align the two holes in the motor mounting plate (E)
Fig. 11 with the two holes (B) in the stand top (A).
3. Insert the shaft (D) through the holes in the motor
mounting plate and the holes in the stand top.
4. Attach the two "C" rings (C) Fig. 11 to the shaft.
5. Align the four holes on the motor bracket with the
four holes (C) Fig. 12, on the motor mounting plate.
NOTE: Confirm that the motor pulley (A) Fig. 12 is
mounted on the same side and the belt-opening
hole (B).
6. Insert a round head flange screw (M8x1.25x16mm)
through the hole in the motor bracket and the hole
in the motor mounting plate.
7. Thread a hex flange nut (M8x1.25) on the screw.
8. Repeat this process for the three remaining holes.
9. Align the four holes (A) Fig. 13 in the leg with the four
holes in the side of the stand top (B).
10. Insert a round head flange screw (M8x1.25x16mm)
through the hole in the leg and through the hole in
the top of stand.
11. Thread a flange nut (M8x1.25) on the screw.
NOTE: Loosely tighten the hardware for further
adjustment.
12. Repeat this process for the three remaining holes.
13. Attach the other three stand legs in the same
manner.
A
E
B
d
C
C
A
B
A
B
E
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
Fig. 11
Fig. 12
Fig. 13