What To Do If You See a Blank Screen

If you see a blank screen or a blue screen with the message No Signal after turning on your computer or video source, do one of the following:

■Make sure the cables are connected correctly, as described in Chapter 1.

■Make sure the Power light is green and not flashing and the lens cap is off.

■If you’ve connected more than one input source, you may need to press the Source button on top of the projector or the Computer, Video, or S-Videobutton on the remote control to select the source you want to use. (Allow a few seconds for the projector to sync up after pressing the button.)

Source button

Computer, Video, and S-Video buttons

■Try restarting your computer.

■If you still don’t see an image and you’re using a PowerBook, see page 26 for additional steps. If you’re using a PC laptop, see page 27.

Using the Projector 25