P S B A flash | When all the lights flash, your printer may have an internal error. Make |
| sure you removed all the packing material as described on the Start |
| Here poster. Then turn off the printer, wait a few seconds, and turn it |
| on again. If the lights still flash, contact your dealer or EPSON; see |
| page 41 for contact information. |
|
|
P S B A are off | When all the lights are off, the printer is not receiving power. Try these |
| solutions: |
| ■ Make sure the printer is turned on. |
| ■ Turn off the printer, plug in the power cord securely, and turn on |
| the printer again. |
| ■ Make sure the outlet is operable and is not controlled by a switch |
| or timer. If in doubt, try using another outlet. |
|
|
You can run a printer check to determine whether a problem comes from the printer itself or some other source. Follow these steps:
1.Make sure both the printer and computer are turned off.
2.Disconnect the interface cable from the printer.
3.Make sure paper is loaded in the printer.
4.Hold down the S load/eject button, then press and release the Ppower button. Continue holding down the S load/eject button until the Ppower light starts to flash, then release it.
The printer prints one page showing its ROM version number, ink counter, and a nozzle check pattern. Only the nozzle check pattern is shown below. (If the pattern has gaps in its dots, you need to clean the print head; see page 21.)
5.To end the check, turn off the printer after it prints the check page. Then reconnect the interface cable and turn on your printer and computer.
If the check page prints, the problem probably lies in your software settings, the interface cable, or your computer.
If the check page doesn’t print, you may have a problem with your printer.
Try the suggestions in “Problems and Solutions” beginning on page 34. If nothing seems to work, contact your dealer or EPSON as described on page 41.
33