Epson D28114 instruction manual and 5 Cutting Wheels, Sanding Discs, Wire Wheels, Accessories

4-1/2" and 5" Cutting Wheels

6" Cutting Wheels Sanding Discs

English

Type 1 guard	Type 1 guard
Quick-change	Quick-change
wheel release	wheel release
abrasive cutting wheel	diamond cutting wheel
clamp nut	clamp nut

Type 1 guard

Quick-change wheel release

abrasive cutting wheel

clamp nut

Type 1 guard

Quick-change wheel release

diamond cutting wheel

clamp nut

rubber backing pad

sanding disc

threaded clamp nut

Wire Wheels

	Type 27 guard
Type 27 guard

3" wire cup
brush	4" wire wheel

NOTE: If the gear case and motor housing become separated by more than 1/4", the tool must be serviced and re-assembled by a DEWALT service center. Failure to have the tool serviced may cause brush, motor and bearing failure.

4.Re-install screws to attach the gear case to the motor housing. Tighten screws to 18 in./lbs. torque. Overtightening could cause screws to strip.

5.Re-install guard and correct flanges for the appropriate accessories.

Accessories

It is important to choose the correct guards, backing pads and flanges to use with grinder accessories. See pages 6–8 for information on choosing the correct accessories.

WARNING: Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other accessories running over rated accessory speed may burst and cause injury. Threaded accessories must have a 5/8"-11 hub. Every unthreaded accessory must have a 7/8" arbor hole. If it

7