Turning on and Projecting• When using the "Direct
Power On" feature, the
power turns on when the power cable is connected.
• When using above an altitude of about 1500 m, make sure you set the “High Altitude Mode” to “On”.
● Adjusting Position and Focus ●
(Setting up for the first time or after moving)
■Raising the Projection Position (Adjusting the front foot)
Foot Adjust
Lever
English
Control Panel | Remote Control |
| (Accessory |
| Power Cable) |
Power Indicator | * For video equipment, |
| press "play" to start |
| playback. |
When moving the projector, make sure the front foot is retracted.
Correcting Keystone Distortion
You can adjust the vertical tilt to a maximum of about 30°*.
Wide Top |
|
| Normal Wide Base | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You can adjust the front foot to raise the projection angle up to a maximum of 10°.
• When the "Auto Keystone" function
is turned "Off" in the configuration menu, automatic keystone correction is not performed.
•You can also make keystone corrections from the configuration menu.
Reading the Indicators
Lit 
Flashing
Orange Standby
Press 
to start
● No image is projected ●
■For notebooks and computers with liquid
crystal displays | Examples |
*The greater the angle of tilt, the harder the image is to focus. Setup the projector at a lower angle of tilt.
•Hold down 
and press 
for more than one second to reset the correction value to the default setting.
•Adjust the horizontal tilt by turning the left rear foot.
projecting.
In this mode, you can unplug the power cable.
Green Warming up
Wait for a short time (about 30 seconds).
In this mode pressing 
has no effect.
Green Projecting
Change the computer’s output source. Hold
down the 
key and press the appropriate 
key (the one usually labelled 
/
). After changing the setting, wait a few seconds for projection to start.
Computer’s "User’s Guide"
*If the image is not
projected, press 
.
NEC
Panasonic
SOTEC
HP
TOSHIBA
IBM
SONY
DELL
FUJITSU
Macintosh Set mirror setting or display detection. Depending on your OS, you can select them by
Rear Adjustable
Foot
Extend 
Retract
■ Adjusting Focus | ■ Adjusting Projection Size |
Enlarge Reduce
After keystone correction and sharpness adjustments, the image may be unfocused.
■For video equipment
Start playback then press 
.
pressing 
.
● Turning the Projector off ●
Turn off all connected equipment.
Press 
twice on the remote control or control panel.
After the confirmation buzzer beeps
twice, unplug the power cable.
Electricity is consumed if only the projector's power is turned off.
Attach the lens cover.
* If you turn the power on straight after turning it off, the time before projection starts becomes longer than usual.
iii