63
EMP-735 User’s Guide
(Warning) Indicator: lit : flashing
Status Cause Remedy or Status
High internal
temperature
(overheating)
The lamp will turn off automatically and
projection will stop. Wait for about 5 minutes
without operating the projector. After about 5
minutes have elapsed, unplug the power cable
and then check the following two points.
•Check that the air filter and air exhaust vent
are clear, and that the projector is not
positioned against a wall.
•If the air filter is dirty, it should be cleaned.
When the power cable is plugged back in, the
projector will return to its previous state, so
press the [Power] button on either the
projector's control panel or the remote control
to turn it back on. If the projector continues to
overheat even after the above points have been
checked, or if the indicators show a problem
when the power is turned back on, stop using
the projector, disconnect the power cable from
the electrical outlet, and contact your dealer or
the nearest address provided at "International
Warranty Conditions" in Safety Instructions/
World-Wide Warranty Terms.
p.12
p.85
Red