64
EMP-735 User’s Guide
Tip :
• If the projector is not operating properly even though the indicators are all showing
normal, refer to "When the Indicators Provide No Help" on the following page.
• If an indicator is showing a status which does not appear in the previous tables,
contact your dealer or the nearest address provided at "International Warranty
Conditions" in Safety Instructions/World-Wide Warranty Terms.
Lamp
problem
Disconnect the power cable from the electrical
outlet and then remove the lamp and check if it
is broken. If the lamp is not broken, reinstall it.
Then reconnect the power cable and press the
[Power] button on either the projector's control
panel or the remote control to turn the power
back on.
If the indicators still show a problem, stop
using the projector, disconnect the power cable
from the electrical outlet, and contact your
dealer or the nearest address provided at
"International Warranty Conditions" in Safety
Instructions/World-Wide Warranty Terms.
p.88
If the lamp is broken, replace with a new lamp,
or contact your local dealer for further advice.
If replacing the lamp yourself, be careful to
avoid pieces of broken glass.
(Projection cannot be carried out until the
lamp is replaced.)
p.88
Check that the lamp and the lamp cover are
securely installed. If the lamp or lamp cover is
not securely installed, the lamp will not switch
on.
p.88
Internal
problem
Stop using the projector, disconnect the power
cable from the electrical outlet, and contact
your dealer or the nearest address provided at
"International Warranty Conditions" in Safety
Instructions/World-Wide Warranty Terms.
High-speed
cooling in
progress
(This is not an abnormality, but if the
temperature rises too high again, projection
will stop automatically.)
•Set the projector up in a place which is well-
ventilated, and so that the air filter and air
exhaust vent are clear.
•Clean the air filter.
p.12
p.85
Status Cause Remedy or Status
Red
(0.5-
second
intervals)
Red
(1-second
intervals)
Orange
Using the Indicators