73
EMP-735 User’s Guide
Network Problems
f Is the projector computer correctly connected to the network?
Check that the network cable is properly connected. If the cable is not connec ted, or is
incorrectly connected, please connect it properly.
f Are the settings for connecting to a network correct?
Check the Network advanced settings. "Connecting in Access Point Mode or Wired
LAN Connection Mode" in the EasyMP Setup Guide
f Has "Standby Mode" been set to "Network ON"?
If using the mail notification function while the projector is in standby mode, change the
"Standby Mode" menu setting to "Network ON". "Advanced" - "Standby Mode" p.54
f Has a critical problem developed causing the projector to momentarily
stop working?
When the projector has momentarily stopped working, it cannot send e-mail messages. If
the projector cannot be reset even after it has been checked, contact your dealer or the
nearest address provided in the "International Warranty Conditions" section of the Safety
Instructions/World-Wide Warranty Terms booklet.
f Is power being supplied to the projector?
Check if the power supply to the location where the projector is set up has been
interrupted, or if the circuit breaker for the electrical outlet that the projector is connected
to has been tripped.
f Is the projector computer correctly connected to the network?
Check that the network cable is properly connected. If the cable is not connec ted, or is
incorrectly connected, please connect it properly.
f Are the settings for connecting to a network correct?
Check the Network advanced settings. "Connecting in Access Point Mode or Wired
LAN Connection Mode" in the EasyMP Setup Guide
f Has EMP Monitor function been correctly installed to the computer ?
Uninstall EMP Monitor and then re-install it. "Installing EasyMP Software" and
"Uninstalling EasyMP Software" in the EasyMP Setup Guide
f Have all projectors that are to be monitored and controlled been
registered in the projector list?
Register the projector in the projector list. "Monitoring and Control Using EMP
Monitor" in the EasyMP Operation Guide

Mail notification messages are not being sent when a problem

occurs with the projector.

The projector cannot be monitored and controlled using the EMP

Monitor function.