Epson EMP-TW500 Problems relating to images, on, button, Was the, computer images, computer images, settings correct, accessory screen, settings correct, the image signals

Problem Solving

Problems relating to images

No images appear

Have you pressed the [Power] Press on the remote control or on the projector's control panel. button?

Was the	indicator lit orange	Disconnect the power cable and then reconnect it.
before the power was turned		Setup Guide
on?		Check the circuit breaker to see if power is being supplied.

Is blank mode active?Press on the remote control to cancel the blank function.

Is a video signal being input? Check if the power for the connected equipment is turned on. If the "Message" menu command has been set to "ON", messages relating to the image signals will be displayed.

"Setting" - "On-Screen Display" - "Message" p.21

Are the image signal format Use the "Video Signal" menu command to select the signal format

settings correct?which matches the connected signal source. "Setting" - "Input Signal" - "Video Signal" p.22

Have the configuration menu Try resetting all of the current settings. p.23 settings been made correctly?

Were the projector and the If the connection is made while the power is already turned on, the

computer connected while function (Fn) key that switches the computer's video signal to external

their power was turned on? output may not work. Turn off the power for the projector and the

Only when projecting computer images

computer and then back on again.

Is the computer display output The image signals need to be output externally. Change the output

set to only the computer's setting to an external destination only or to an external destination as

accessory screen?well as the computer's own monitor.

Only when projecting

Computer documentation, under a title such as "External output" or

computer images

"Connecting an external monitor"

The message "Not Supported." is displayed

Are the image signal format If a composite video or S-Video signal is being input

settings correct?If projection does not occur when the "Video Signal" menu command is set to "Auto", select the signal format that matches the signal source. "Setting" - "Input Signal" - "Video Signal" p.22

		If connected to the [InputA] or [InputB] port
		Check that the connectors of the connection cable are inserted into the
		correct ports.	Setup Guide
Does the mode match the		Use the "Resolution" menu command to check the signals being input,
frequency and resolution of		and check the "List of Supported Monitor Displays" to make sure that
the image signals?		the signals are compatible.
		"Info" - "Resolution" p.15
	Only when projecting
		"List of Supported Monitor Displays" p.45
	computer images

34