Problem Solving
Image colours are not right
Are the image signal format If a composite video
or 
settings correct?If projection does not occur when the "Video Signal" menu command is set to "Auto", select the signal format that matches the signal source. 
"Setting" - "Input Signal" - "Video Signal" p.22
If the signal source is connected to the [InputA] port, [InputB] port or [D4] port
Use the "Input Signal" menu command to set the signal format that matches the signal that is being projected from the connected equipment.
"Setting" - "Input Signal" p.22
You can also press 
, 
or 
on the remote control to
select the format. 
Setup Guide
Are the cables connected | Check that all of the cables required for projection are securely | |
correctly? | connected. | Setup Guide |
|
| |
| Has the image Contrast | Use the "Contrast" or "White Level" menu command to adjust the | |
been adjusted correctly? | contrast. |
|
| "Image" - "Picture Quality" - "Input Adjustment" p.16 | |
|
| |
| Has the colour been adjusted | Use the "Color Adjustment" menu command to adjust the colour. | |
correctly? | "Image" - "Color Adjustment" p.17 | |
Have the colour intensity and Use the "Color Intensity" and "Tint" menu commands to adjust the
tint been adjusted correctly? colour and tint."Image"- "Picture Quality" - "Color Intensity", "Tint" p.16
Images appear dark
Has the image brightness been | Use the "Input Adjustment" and "Brightness" menu commands to make | |
adjusted correctly? | the adjustments. |
|
| "Image" - "Picture Quality" - "Input Adjustment", "Brightness" p.16 | |
|
| |
| Has the image contrast | Use the "Contrast" or "White Level" menu command to adjust the | |
been adjusted correctly? | contrast. |
|
| "Image" - "Picture Quality" - "Input Adjustment" p.16 | |
|
| |
| Is the lamp due for | When the lamp is nearly due for replacement, the images will become | |
| replacement? | darker and the colour quality will become poorer. When this happens, | |
| the lamp should be replaced with a new one. | |
|
|
|
Projection stops automatically
Is sleep mode active?If the projector remains on while no images signals are being input, after a while the lamp will automatically turn off and the projector will switch
to standby mode. Press the 
button on the remote control or the 
button on the projector's control panel to turn the projector's power back on. To cancel the sleep mode setting, change "Sleep Mode" menu command to "OFF".
"Setting" - "Operation" - "Sleep Mode" p.20
Troubleshooting
37