Preparing the Remote Control

Inserting batteries into the remote control

The remote control is not supplied with batteries already inserted. Insert the accessory batteries before using the remote control.

the

1 Remove the battery cover.

While press the knob, lift up.

3 Install the battery cover.

1 Insert the tab

2 Press down until the battery cover clicks into place.

2

1

Installing Projector

2 Insert the batteries.

cCaution: Check the (+) and (-) indications inside the battery compartment and insert the batteries so that they face correctly.

QTip: If delays in the responsiveness of the remote control occur or if it does not operate after it has been used for some time, it probably means that the batteries are becoming flat. If this happens, replace the batteries with two new batteries. Use two new AA batteries as replacement batteries.

Using the remote control

■Operating range (horizontal)

Remote control light-receiving area

Operating distance

Approx. 10m

Approx. 30° Approx. 30°

Approx. 30° Approx. 30°

Remote control

light-emiting area

■Operating range (vertical)

Operating distance

Operating distance

Approx. 10m

Approx. 10m

Approx. 30°

Approx. 30°

Approx. 30°

Approx. 30°

13