Problem Solving

■Projection stops automatically

Is sleep mode active?

When "Sleep Mode" has been set to On, the lamp turns off

 

automatically if no signal is input for about 30 minutes, and the

 

projector switches to standby mode. Press the

button on the

 

remote control or the

button on the projector's control panel to

 

turn the projector's power back on. To cancel the sleep mode

 

setting, change "Sleep Mode" menu command to "Off".

 

s "Settings" - "Operation" - "Sleep Mode" page 31

 

 

 

 

Problems when projection starts

■ Power does not turn on

Have you pressed the [Power]

Press on the remote control or

on the projector's control

button?

panel.

 

 

 

 

 

 

Is "Child Lock" set to "On"?

If the "Child Lock" menu command is set to "On", press

on the

 

projector's control panel for about 3 seconds or press

 

on the

 

remoto control to turn the power on.

 

 

 

 

s "Settings" - "Operation" - "Child Lock" page 31

 

 

 

 

Is "Operation Lock" set to "On"?

If the "Operation Lock" menu command is set to "On", all buttons

 

on the projector’s control panel are disabled. Press

on the

 

remote control.

 

 

 

 

s "Settings" - "Operation" - "Operation Lock" page 31

 

 

 

Are all of the indicators

Disconnect the power cable and then reconnect it. s page 14

switched off?

Check the circuit breaker to see if power is being supplied.

 

 

Do the indicators turn off and on

Turn the power off, disconnect the power cable and then reconnect

when the power cable is

it. If this does not solve the problem, there may be a problem with

touched?

the power cable. Then contact your dealer or the nearest address

 

provided at "International Warranty Conditions" in Safety

 

Instructions/World-Wide Warranty Terms booklet.

 

 

 

 

 

 

 

Problems with the remote control

■The remote control does not work

Is the remote control light-

Face the remote control towards the remote control light-receiving

emitting area facing towards the

area.

remote control light-receiving

The operating angle for the remote control is approximately ±30°

area when it is operated?

horizontally and approximately ±30° vertically. s page 13

 

 

Is the remote control too far

The operating range for the remote control is approximately 10m.

from the projector?

s page 13

 

 

Is direct sunlight or strong light

Set the projector up in a location where strong light will not shine

from fluorescent lamps shining

onto the remote control light-receiving area.

onto the remote control light-

 

receiving area?

 

 

 

Are the batteries dead, or have

Insert new batteries, while making sure that they face correctly.

the batteries been inserted

s page 13

correctly?

 

 

 

Troubleshooting

41