Problem Solving

When the (operation) indicator is lit or flashing normal

When the

(warning) indicator is off

: Lit

: Flashing

Orange Standby condition

If you press , projection will start after a brief interval.

 

 

Warm-up in

 

 

Green

Warm-up time is approximately 30 seconds.

 

progress

 

 

Power off operations are ignored while warm-up is in progress.

 

 

 

 

 

 

 

 

 

 

 

 

 

Projection in

 

 

Green

 

 

progress

Normal operation is in progress.

 

 

 

 

 

 

 

 

 

 

Orange Cool-down in

progress

Cool-down time is approximately 30 seconds.

After cool-down is complete, the projector goes to standby mode.

You cannot use the remote control or the projector's control panel during cool-down.

If the main power switch at the rear of the projector is turned off before cool-down is complete, wait for the lamp to cool down (normally about one hour is required) before turning the power back on again.

When the indicators provide no help

If any of the following problems occur and the indicators do not offer a solution, refer to the pages given for each problem.

Problems relating to images

No images appear s page 37

Projection does not start, the projection area is completely black, the projection area is completely blue, etc.

Moving images are not displayed s page 37

Moving images played on computer are not displayed.

The message "Not Supported." is displayeds page 38
The message "No Signal." is displayed s page 38
Images are fuzzy or out of focus s page 38
Interference or distortion appear in images s page 39

Problems such as interference, distortion or black & white checked patterns appear.

Image is truncated (large) or small s page 39

Only part of the image is displayed.

Image colours are not right s page 40

The whole image appears purplish or greenish, images are black & white, colours appear dull, etc.

(Computer monitors and LCD screens have different colour reproduction performance, so that the colours projected by the projector and the colours appearing on the monitor may not necessarily match, but this is not a sign of a problem.)

Images appear dark s page 40
Projection stops automatically s page 41

 

 

Problems

when projection starts

 

 

 

Problems

with the remote control

 

 

 

 

 

 

 

 

 

 

 

 

Power does not turn on s page 41

 

 

 

The remote control does not work

 

 

 

 

 

 

 

 

s page 41

 

 

 

 

 

 

 

 

 

 

 

36