Reset All

All printer settings for all interfaces have been reset to the default configuration.

Reset to Save

You have changed a SelecType setting but the new value is not activated yet. Do one of the following: (1) exit SelecType by pressing Continue or On Line (the new setting is activated after the current print job is finished), or (2) reset the printer by pressing ALT and Reset at the same time.

Self Test

The printer is performing its internal self test; wait a few moments for it to finish.

Service Req.Cnnn

Service Req.Ennn

A controller error (Cnnn) or a print engine error (Ennn) has occurred. Write down the error number and turn off the printer. Wait at least five seconds and then turn it back on. If the error message still appears, turn off the printer, unplug the power cord, and contact an authorized EPSON Customer Care Center.

Standby

The printer is in its low power state. If the On Line light is on, it is still on line and you may send a print job.

Toner Low

The printer is almost out of toner. You should replace the imaging cartridge soon; see Chapter 5 for instructions.

6-6Troubleshooting