
Setting | Options | Description |
|
|
|
Various settings from | Sets the amount of time the | |
| 5 to 300 seconds | printer waits to receive |
| (60 sec. default) | data before terminating an |
|
| incomplete print job; after |
|
| the |
|
| another print job can print. |
|
|
|
Toner Save | ON | Sets the amount of toner |
Mode | OFF | used in your print job. If |
|
| you’re printing a draft |
|
| copy, set to ON to use |
|
| around 50% less toner for a |
|
| lighter printout. |
|
|
|
Low Power | ON | Sets the printer to enter a |
Consumption | OFF | |
|
| mode if it is not used for 30 |
|
| minutes. (The printer takes |
|
| about 1 minute to warm up |
|
| after exiting standby mode.) |
|
|
|
Auto Continue | ON | Sets the printer to use Auto |
| OFF | continue mode to continue |
|
| printing 5 seconds after |
|
| recovering from an print |
|
| overrun or insufficient |
|
| memory error. It is best to |
|
| leave Auto continue OFF so |
|
| you are alerted to errors; |
|
| then you must press the |
|
| Continue button on the |
|
| control panel to resume. If |
|
| you’ll be away from the |
|
| printer and are aware of |
|
| possible errors, you can turn |
|
| on Auto continue mode. |
|
|
|