Epson G5200WNL when analog (75, setting). Enable, power button). Enable, EasyMP Operation Guide, 108Fine-Tuningthe Projector

note

If Direct Power On is enabled, the power cord is connected, and a power outage occurs, the projector will start when the power is restored.

Do not use the projector at altitudes above 7,500 feet (2,286 meters).

P power button). Enable Sleep Mode if you want the projector to turn off automatically if it is idle (and no signal is received) for 10 minutes (you can adjust the amount of time using the Sleep Mode Timer setting). Enable High Altitude Mode when you are using the projector above 4,900 feet (1,500 meters). Enable BNC Sync Termination when analog (75Ω) termination (such as for switchers) is necessary.

■Standby Mode

Select Network On to enable the projector to be monitored over a network when it is in standby mode (the power light is orange).

■Projector ID

Lets you assign a numeric ID to each projector. When you are using multiple projectors, you can use the ID to select the one you want to operate with the remote control. See page 57 for instructions.

■Multi-screen

Use this option if you want to color-match two or more projectors that are being used to display images near each other, or you are using the multi-screen feature to project from one source (one image) with multiple projectors (see the EasyMP Operation Guide). You can make image adjustments at each of five adjustment levels. First choose an Adjustment Level and then adjust the settings for each level: Brightness Correct to adjust the brightness, and Color Correct to adjust the balance between red and green, or blue and yellow. See page 109 for more information about multi-screen color adjustment.

■Language

Select from 20 languages to be used for the projector menus.

108Fine-Tuning the Projector