Epson G5200WNL While holding the, While holding the, Checking the Projector ID, Setting the Remote Control ID, 58Presenting With the Remote Control

Checking the Projector IDYou can check the projector’s ID by following these steps:1.Point the remote control at the projector you want to check.

2.While holding the ID button, press the Help button. You see a message on the screen like this:

note

If you’re using a remote control ID other than the default ID of zero, you have to set the ID each time you turn on the projector.

note

When the remote control ID switch is in the Off position, you can control any projector regardless of the projector or remote control ID settings.

Setting the Remote Control ID

The remote control’s default ID is zero. This lets you operate any projector. To set it to operate a specific projector, follow these steps:

1. Move the remote control ID switch to the On position.2. Press and hold the ID button on the remote control.

3.While holding the ID button, press a numbered button on the remote control (0 through 9) to select the desired ID. Select zero to control all projectors, or select a number to match the ID of the projector(s) you want to operate.

58Presenting With the Remote Control