Plugging in the Printer

1

1.Make sure that the printer is turned off. It is off when the P Power button protrudes slightly from the surface of the control panel.

2.Check the label on the back of the printer to make sure the voltage required by the printer matches that of the electrical outlet you will be plugging it into. Also, make sure that you have the correct power cable for your power source.

cIt is not possible to change the printer's voltage. If the rated voltage and your outlet voltage do not match, contact your dealer for assistance. Do not plug in the power cord.

3.If the power cord is not attached to the printer, connect it to the AC inlet on the back of the printer.

4.Plug the power cord into a properly grounded electrical outlet.Caution:Installing the Ink CartridgesBefore installing the ink cartridges, note the following.

wThe ink cartridges are self-contained units. Under ordinary use, ink will not leak from a cartridge. If ink does get on your hands,

wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water.Warning:

Setting Up Your Printer 1-3