Unplug the printer and refer servicing to qualified service personnel under the following conditions:

The power cord or plug is damaged; liquid has entered the printer; the printer has been dropped or the cabinet damaged; the printer does not operate normally or exhibits a distinct change in performance.

If you plan to use the printer in Germany, observe the following:

To provide adequate short-circuit protection and over- current protection for this printer, the building installation must be protected by a 16 Amp circuit breaker.

Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit einem 16 A-Überstromschalter abgesichert ist.

A Few PrecautionsWhen using the printer

Do not put your hand inside the printer or touch the ink cartridges during printing.

Do not move the print head by hand; otherwise you may damage the printer.

Always turn the printer off using the P Power button. When this button is pressed, the Power light flashes briefly then goes off. Do not unplug the printer or turn off the power to the outlet until the Power light stops flashing.

Before transporting the printer, make sure the print head is in the home (far right) position and the ink cartridges are in place.

2