3. If the optional tractor is installed in the pull tractor position,
remove it. Make sure the paper tension unit is not installed.
Note:
Store the paper guide, optional pull tractor, and paper tension unit
in a safe place; you will need to reinstall them if you remove the
cut-sheet feeder.
4. Gently move the print head to the ribbon installation position.
wWarining:
Never move the printhead while the printer is turned on; this
can damage the printer. Also, the print head may beco me hot
during use. Always let it cool before you touch it.
5. Hold the cut-sheet feeder in both hands and on both sides of the
feeder. Fit the notches over t he mounting pos ts on the printe r.
Lower the cut-sheet feeder until it rests on the printer.
6. Insert the cable into the connector a s shown above.
7. Replace the printer cover.
You are now ready to load paper with your cut-sheet feeder . T o
remove the cut-sheet feeder, reverse the steps above.
4-1
R
Sunflow er-P
Rev.c A5
size Chapter 4
01/09/96 pass 1
Using Printer Options 4-3