Panel light

Beep

Problem

 

 

state

pattern

 

 

 

Solution

 

 

 

 

 

 

 

 

 

 

 

 

 

f Paper Out

•••

Continuous paper is not fed back to the

 

 

n Pause

 

standby position.

 

 

 

 

 

 

 

 

 

 

 

Tear off the printed document at the

 

 

 

 

 

perforation; then press the Load/Eject button.

 

 

 

 

 

The printer feeds the paper to the standby

 

 

 

 

 

position. Press the Pause button to turn off the

 

 

 

 

 

Pause light.

 

 

 

 

 

 

 

 

 

 

•••

A single sheet of paper is not fully ejected.

 

 

 

 

 

 

 

 

 

 

 

Press the Load/Eject button to eject the sheet.

 

 

 

 

 

Then press the Pause button to turn off the

 

 

 

 

 

Pause light, if necessary.

 

5

 

 

 

 

 

 

 

•••

Paper is jammed in the printer.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Clear the paper jam as described in “Clearing

 

 

 

 

 

 

 

 

 

Paper Jams” on page 5-16.

 

 

 

 

 

 

 

f Paper Out

•••

The printer was unable to switch between paper

 

 

f Pause

 

sources because of a paper jam or other paper

 

 

 

 

 

problems. (LQ-680Pro only)

 

 

 

 

 

 

 

 

 

 

 

Remove any paper from the paper path and

 

 

 

 

 

clear the paper jam as described in “Clearing

 

 

 

 

 

Paper Jams” on page 5-16.Then retry the

 

 

 

 

 

paper source selection.

 

 

 

 

 

 

 

f Pause

–

The print head is overheated.

 

 

 

 

 

 

 

 

 

 

 

Wait a few minutes; the printer resumes printing

 

 

 

 

 

automatically once the print head has cooled.

 

 

 

 

 

 

 

f All the lights

• • • • •

An unknown printer error has occurred.

 

 

on the control

 

 

 

 

 

Turn off the printer and leave it off for several

 

 

panel

 

 

 

 

 

 

minutes; then turn on the printer again. If the

 

 

 

 

 

error recurs, contact your dealer.

 

 

 

 

 

 

 

 

n= on, f = flashing

•••= short series of beeps (three beeps)

• • • • • = long series of beeps (five beeps)

Note:

The printer beeps once if you press a control panel button when the corresponding function is not available.

Troubleshooting 5-3