❏Because labels are especially sensitive to temperature and
humidity, use them only under normal operating conditions.
Make sure the printing stays entirely within the printable area.
(See the Appendix for specifications.)
❏Don’t leave labels loaded in the printer between jobs; they curl
around the platen and may jam when you resume printing.
❏To remove the labels from the printer, tear off the fresh supply
at the rear of the printer; then press LF/FF to advance the
remaining labels out of the printer.
cCaution:

Never feed labels backward through the printer; they can easily

peel off the backing and jam the printer. If a label does become

stuck in the printer, contact your dealer.

Envelopes
You can feed envelopes individually using the paper guide.
❏Before loading an envelope, set the paper thickness lever to 2
or 3. See page 2-16.
❏To load an envelope, follow the steps in “Running the Self
Test” on page 1-10. Insert the wide edge of the envelope into
the printer first, printable-side down. When you insert the
envelope between the paper guides, push it firmly and hold it
until it feeds into the printer.
❏Use envelopes only under normal temperature and humidity
conditions.
❏Make sure the printing stays entirely within the printable area.
The print head must not go past the left or right edge of the
envelope or other thick paper. (See the Appendix for
specifications.) It’s a good idea to print a test sample using a
normal single sheet of paper before you print on the envelopes.
L
Blueberry REV.F
A5 size Chapter 2
95/05/25
2-18 Using the Printer