INSTALLATION OF MX-80 F/T TYPE II

1. Unpacking

Before removing the MX-80 F/T Type II from the carton, check the box for evidence of shipping damage or mishandling. If such evidence is present, notify the carrier immediately.

1.1. Unpacking steps

Unpacking steps are as follows:

STEP 1. Open the carton.

STEP 2. Remove accessories.

STEP 3. Remove the MX-80 F/T Type I I by holding its underside and lifting it straight up with the packing material attached.

STEP 4. Place the Printer with the packing material on a table or any other convenient flat surface.

STEP 5. Take off the packing material carefully.

STEP 6. Remove the vinyl cover.

1.2. Repacking steps

Repacking can be carried out by following the above steps in the reverse order. (Repacking: Shipment for repair, storage, etc.)

NOTE: It is recommended that all original packing materials be saved for reuse in case the

MX-80 F/T Type I I requires reshipment in the future.

2. Counting the Parts

The MX-80 F/T Type I I and standard accessories are as shown in Fig. 19. Upon unpacking, if you notice any listed contents missing or evident damage, contact the store where you purchased the MX-80 F/T Type I I as soon as possible.

- 1 7 -