INSTALLATION OF MX-80 TYPE II

1. Unpacking

Before removing the MX-80 Type I I from the carton, check the box for evidence of shipping damage or mishandling. If such evidence is present, notify the carrier immediately.

1.1. Unpacking steps

 

 

Unpacking steps are as follows:

 

 

STEP 1. Open the carton.

 

 

STEP 2.

Remove

accessories.

 

 

STEP 3.

Remove

the MX-80 Type I I holding its underside

and lifting

it straight

 

up with the packing material attached.

 

 

STEP4. Place the

Printer with the packing material on a

table or

any other

 

convenient

flat surface.

 

 

STEP 5.

Take off the packing material carefully.

 

 

STEP 6.

Remove

the vinyl cover.

 

 

1.2. Repacking steps

Repacking can be carried out by following the above steps in the reverse order. (Repacking: Shipment for repair, storage, etc.)

NOTE: It is recommended that all original packing materials be saved for reuse in case the

MX-80 Type II requires reshipment in the future.

2. Counting the Parts

The MX-80 Type II and standard accessories are as shown in Fig. 2. Upon unpack- ing, if you notice any listed contents missing or evident damage, contact the store where you purchased the MX-80 Type I I as soon as possible.

- 3 -