■Check the warning light. If it is flashing orange or red, you need to replace the lamp. See page 49.

■If you’re using external video equipment, check the solutions on page 61.

The DVD skips.

■Make sure MovieMate is not tilted. Tilting it up more than 5 degrees may cause skipping or disc scratches. Use the vertical image adjustment dial to adjust the image position.

■Make sure there are no fingerprints on the DVD.

The remote control doesn’t work.

■Make sure the toggle buttons, or to Func.-

switch is in the correct position: set to -123to use the numeric to use the other functions of these buttons.

■Make sure you’re within 22 feet of MovieMate, and within range of its front or back sensor (approximately 30° left or right, and 15° above or below).

■You may need to replace the remote control’s batteries. Make sure they’re inserted with the positive (+) and negative (–) ends positioned as shown in the battery compartment.

■Some discs don’t support all of the remote control’s functions.

■If you’re using a “universal” remote control, it might not work with MovieMate. Epson does not support any third-party remote controls.

Solving Picture and Sound Problems

The picture is blurry or out of focus.

■Adjust the focus using the focus ring. See page 15.

■Make sure the lens cover is off.

■There may be dirt on the lens. Clean the lens as described on page 47.

■Make sure the lens is not fogged by condensation. If you’ve just moved MovieMate from a cold environment, wait approximately an hour before using it. If condensation forms, turn on the main power switch, then wait an hour or two before use.

■Make sure MovieMate is placed the correct distance from the screen: no closer than 2.4 feet (73 cm) and no farther than 37 feet (11.37 m).

■Adjust the Sharpness setting. See page 44.

58 Problem Solving