Playing MovieMate Audio Through an External Audio System

You can connect MovieMate to an audio receiver, 5.1 Stereo Surround Sound System, or digital audio recorder. To output sound from MovieMate, the external equipment needs to have an optical audio input port.

Note: For additional convenience, Epson has developed an optional Wireless 5.1 Surround Sound System adapter for the MovieMate 30s Series. To find out more about this accessory, go to www.epson.com/homeentertainment.

You will also need an optical digital cable, which may be provided with your external equipment, or may be purchased from an electronics store.

1.Remove the protective cap from the Optical Audio-Outport and keep it in a safe place.

2.Make sure the equipment is turned off, then connect the cable as shown:

Wireless 5.1 Surround Sound System adapter (audio transmitter portion)

Digital audio recorder

Optical digital cable

Audio receiver

3.Turn on your audio equipment and play your movie, music, or other presentation with sound from MovieMate.

4.You can adjust the volume input level by pressing and holding the button for approximately 2 seconds. LEVEL 1 appears on MovieMate’s display window. Press and hold the button again to select LEVEL 2 and increase the volume.

You may also need to change the Digital Audio Output or Downmix settings in the Audio Setup menu. Make sure you use the Stream/PCM setting for surround sound systems. You can also use any of MovieMate’s other audio controls, as described on pages 42 through 43.

Note: After you disconnect your external audio equipment, make sure you replace the cap on the Optical Audio Out port and close MovieMate’s port compartment cover.

28 Using MovieMate With Other Equipment