■If you have an access point or AirPort base station and you’re not using DHCP, check your projector’s IP address on the Access Point mode advanced settings screen. The first three segments of the IP address should be identical to the first three segments of the IP address of your access point or base station. The last segment of the projector’s IP address should be close, but not identical, to the last segment of the IP address of the access point or base station.

■If you’re not using DHCP, check your projector’s Gateway address on the projector’s Access Point mode advanced settings screen. It should be identical to the IP address for your access point or AirPort base station.

■If you’re using a projector keyword, it changes each time you turn the projector off and then on again, or remove and reinsert the 802.11g wireless card. Check the projector’s keyword on the EasyMP Network screen and enter it at the prompt.

■If you’re using AirPort, check the configuration of your network. Start the AirPort Admin utility, select your base station, click

Configure and click Show All Settings. Click the Network tab. If you set up your projector to connect in DHCP mode, turn on Distribute IP Addresses and Share a Single IP Address.

■If you’re using AirPort and DHCP is turned off on your projector’s Access Point mode advanced settings screen, make sure

Distribute IP Addresses is off.

■If you’re using Access Point mode and you’re connecting to the wrong network, you may be experiencing signal interference from another network. Try resetting your access point or base station, then restart NS Connection.

■If you’re using AirPort, the projector’s ESSID should match the AirPort network name, not the name of the AirPort base station. To check the network name, start the AirPort Admin utility, select your base station, and click Configure. Then click Show All Settings. The network name appears on the AirPort tab.

■

■

If you’re prompted for a password when you connect, enter the WEP encryption key (if you’re using WEP encryption).

Try connecting using IP Connect Mode; see page 77.

Solving Problems 165