2Using the Projector

note

If you have more than one source connected, you may have to switch to the one you want to use, as described on page 25.

Once you’ve connected the projector to your computer or other equipment (as described in Chapter 1), you’re ready to turn on the projector, adjust the image, and give your presentation. This chapter covers the following:

■Turning on the projector and other equipment■Adjusting your image■Using the remote control■Controlling audio and video■Highlighting your presentation■Shutting down the projector and other equipment

Turning On Your Equipment

Make sure your projector and other equipment are set up and connected correctly, as described in Chapter 1. Then plug in and turn on your equipment, as described below.

Follow these steps to plug in and turn on your equipment:

1. If you’re projecting video, first plug in and turn on your VCR, DVD player, or other video source. (If you’re projecting from a computer, go to step 2.)

2.To turn on the projector,

first connect one end of the power cord to the projector’s power inlet on its left side.

Using the Projector 23