cCaution:

❏Never use alcohol or thinner to clean the product. These chemicals can damage the product.

❏Take care to prevent water from getting inside the product. If moisture, dirt, or other matter gets inside of the product, besides affecting print quality, it may cause the electric circuits to short.

1.Make sure the product is turned off and all the lights are off, and then unplug the power cord from the electrical outlet.

2.Use a soft, clean cloth to carefully remove any dust or dirt.

If the dirt does not come off, clean it using a soft, clean cloth dampened with a mild detergent. Then, wipe the outside of the product dry with a dry, soft cloth.

Note:

❏After cleaning the product, close the disc cover and the Stacker 4 tray to protect the product from dust.

❏Make sure to clean the filter that is located on the rear of the product at regular intervals. See the next section.

Cleaning the interior of the product

To keep your printouts at their best, clean the inside by using the following procedure.

1.Make sure the product is turned off and all the lights are off, and then unplug the power cord from the electrical outlet.

2.Open the disc cover, and remove the stackers from the product.

3.Use a soft, clean cloth to carefully remove any dust or dirt from the stackers and inside of the product.

Maintaining Your Product 62