Starting the ProgramFollow these steps to start the System diagnostics program:1.Insert the Reference diskette in drive A and turn on or reset the computer.

Note

Always boot the computer from the Reference diskette to start System diagnostics. This clears any terminate-and- stay-resident (TSR) programs or other utilities from memory and frees it for use by the diagnostics program.

2.At the A : prompt, type DIAG and press (br9rl.

3.You see a menu bar at the top of the screen with Items Detected highlighted. Press I.

4.You see a list of all the testable devices the computer detects in your system. Check to be sure the list is correct.

5.If the list is not correct, press m to select Quit and press LEnr). Run the SETUP program to make sure any missing devices are configured properly. (See Chapter 2 of the Setup Guide for instructions.) Then run System diagnostics again beginning at step 1.

When the list is correct, you can run diagnostic tests on each device. If you do not want to test a device, you can remove it from the list. You can also add a device to the list.

5-2 Running System Diagnostics