Follow these steps to run SETVOL:

1.If you copied SETVOL.EXE to your hard disk, log onto the directory where it is stored.

If you did not copy the file, insert the Reference diskette in drive A and log onto that drive.

2.At the command prompt, type the following and press [En*rl:SEWOL

3.You see the volume selection menu. The VOLUME box at the top of the screen shows the percentage of volume currently set for your speaker, such as 50%. The solid bar in the middle of the screen graphically displays the volume setting as you increase or decrease it.

To decrease the volume, press [tl, l-T-1, or [-1. To increase the volume, press [-t,[7], or r;7. (You can use the keys on the main keyboard or the numeric keypad.)

As you change the volume, the speaker beeps so you can test the volume of the current setting.

4.After you have selected the volume you want, press [Enl#l to store the current setting and exit SETVOL. You see a message confirming the volume setting you selected.

If you want to exit the program without saving the new setting, press [ You see the operating system command prompt.

The speaker volume you set remains in effect until you change it again.

Using Your Computer 1-35