3.Gently push the SIMM into the socket and then tilt it left until it is vertical, guiding the holes at each end of the SIMM over the retaining posts at each end of the SIMM socket.

retaining post

hole

The SIMM should snap into place over the retaining posts. If it does not go in smoothly, do not force it; pull it all the way out and try again.

Make sure the SIMM is fully inserted into the socket and that the pins on the retaining posts extend through the holes in both ends.

4.If you are installing a second SIMM, repeat steps 2 and 3 to install it in the other socket.

5.After you replace the computer’s cover, be sure to run the SETUP program so your system can update its configuration. See Chapter 2 of the Setup Guide for instructions.

Installing and Removing Options 3-15